Partech MicroMac C Colorimetric AnalyserThe analytical methods used in the MicroMac C are based on the Standard Methods that are used in laboratories throughout the world. Many of these methods have their basis in the “Methods for the Examination of Waters and Associated Materials” as published by HMSO – Standing Committee of Analysts.The Loop Flow Analysis system can be configured as a single or multiple chemistry module: The multiple chemistry module can have up to 4 chemistries or 7 reagent additions. The chemistry module shown shows the a typical analysis loop, this can include a high temperature heating bath for hot acid digestion and high pressure valves and PTFE tubing in all areas in contact with the acid or high temperatures when required.Up to seven reagent valves allow the analyser to be configured for multiple chemistries, typical combinations include:Ortho-Phosphate and Soluble IronOrtho-Phosphate and AmmoniaTotal Phosphorus and Iron or AluminiumSpecificationsSample PreparationThe most critical part of any monitor is the sampling system, which must be able to get the sample to the monitor in a condition fit for analysis, Partech have developed a range of sampling systems that perform this task in a way that reduces maintenance time to a minimum. In addition to providing the sampling system Partech provide a full installation and commissioning service. This service ensures that the analyser works from day one and provides the user with full documentation and training on the system.Each site needs to be reviewed on it’s own merits and Partech will work with you to ensure that the most cost effective solution will be offered.Crude Sewage or Process MonitoringThe system developed and fully implemented by Partech incorporates a mascerating submersible pump, air compressor, controller and standard filter unit with 20 micron filter element. This combination makes this arduous application possible and gives the option of feed-forward control when carrying out chemically assisted Phosphate removal.Final Effluent or Surface Water MonitoringMonitoring in these applications allows the use of either a basic system with a simple peristaltic pump or a full sampling system incorporating a submersible pump, air compressor, controller and standard filter unit with 400 micron filter element. The full system is required for locations that have a level change from the sample to the analyser installation or where fouling is believed to be an issue.Potable Water TreatmentMost potable water installations have relatively simple sample requirements and it is normally possible to connect the analyser and it’s sample pot to the site pipework without the need for additional sample conditioning.Alat Uji Kualitas Air
